ASSEMBLY INSTRUCTIONS
1 Hold cable end-loop in one hand and gently toss tubes away from body.
2 While holding tube nearest you, pull cable loop and gently shake tubes into alignment.
3 Align all tube sections to form probe.
4 Slide red nut onto the now protruding silver screw. Grasp end of protruding silver screw with your thumb and forefinger.
5 Rotate red nut clockwise to engage threading while holding screw stationary. 

IMPORTANT NOTE: Do not over tighten red nut. Excess tension along the length of the probe will cause probe to flex unnecessarily. Optimal performance is achieved when red nut and silver screw are finger-tight.

TO DISASSEMBLE
Unscrew red nut while holding silver screw stationary. From tip end, pull apart tubes sequentially and fold into protective bag.